Submit Feedback

Light armor panel side prints through glass

Usernamenotshown shared this bug ago

Solved

Hello, while printing I have seen this block (triangular plate) get built intersecting glass perpendicularly. The distance from the glass to the edge of the previous layer was about 1.25 m, and this 2.5 m x 2.5 m block should need at least 2.6 m of distance. Please take a look.

Files:

I have the same bug

Replies (3)

Usernamenotshown ●

It happens with square panels too, sometimes.

Files:

Reply URL

Andre Thielmann ●

or Rotors attached to its side

URL

Space Engineers Support ●

Hello Engineer,

We've released a new update for Space Engineers.

When you have a moment, could you please update your game to version 208 and verify whether the issue you reported is still occurring?

Your feedback will help us ensure the problem is fully resolved.

Kind regards,

Keen Software House:

QA Department

Reply URL

Usernamenotshown ●

I will try to print something today or tomorrow, please don't close the ticket yet. I have to make some PCU room etc to print it on the servers so the conditions are the same.

URL

Usernamenotshown ●

I put the same ship on the printer, and it was printed flawlessly. Maybe there being only 1-3 players on the server had some influence, but I think this issue is fixed. Thank you.

URL

Ondrej Borz ●

Hello Engineer,

Thank you for your reply.

Happy to hear that you are no longer experiencing this problem.

Since there is no more assistance needed from our side, I will close this thread now.

Please do not hesitate to contact us again, should you observe any other problem in the game, by opening a new thread here on the forum.

Thank you for your understanding.

Happy Engineering!

Kind Regards

Keen Software House: QA Department

Reply URL