Rotor Blueprint Bug
Reported
Picture 2 is what I'm trying to make and picture 1 is what I'm getting even though the Rotor head has been removed from the projected blueprint.
When a rotor with its head removed is projected and assemble from that projection it ads the head even though you probably had a good reason for removing it in the first place.
I have the same bug 
Hello, EDGE,
thanks for pointing this one out!
This issue was successfully reproduced and thus put into our internal system.
Kind Regards
Keen Software House: QA Department
Hello, EDGE,
thanks for pointing this one out!
This issue was successfully reproduced and thus put into our internal system.
Kind Regards
Keen Software House: QA Department
Replies have been locked on this page!