Rotor Blueprint Bug
Reported
Picture 2 is what I'm trying to make and picture 1 is what I'm getting even though the Rotor head has been removed from the projected blueprint.
When a rotor with its head removed is projected and assemble from that projection it ads the head even though you probably had a good reason for removing it in the first place.
I have the same bug 
Access denied
Hello, EDGE,
thanks for pointing this one out!
This issue was successfully reproduced and thus put into our internal system.
Kind Regards
Keen Software House: QA Department
Hello, EDGE,
thanks for pointing this one out!
This issue was successfully reproduced and thus put into our internal system.
Kind Regards
Keen Software House: QA Department
Replies have been locked on this page!