This object is in archive!
Projector is not saving alignment settings
Reported
The Projector is not saving alignment settings. when alignment is correct with the grid it immediately disables any further adjustments(screenshot). Also, there is no longer any info in the lower right box, as was before. All this seems to happen intermittently.
Files:
2022-01-18-00-0...
I have the same bug 
Are you sure you have the "Keep Projection" checkbox ENABLED? Because as soon as you align, it removes the blueprint and you can no longer do anything.
Also, this is kind of stupid that the checkbox is DISABLED by default, and you cannot enable it until you add a blueprint... but if the blueprint you add IS ALIGNED, it immediately removes and you cant set it! Stupid default UX design there.
Are you sure you have the "Keep Projection" checkbox ENABLED? Because as soon as you align, it removes the blueprint and you can no longer do anything.
Also, this is kind of stupid that the checkbox is DISABLED by default, and you cannot enable it until you add a blueprint... but if the blueprint you add IS ALIGNED, it immediately removes and you cant set it! Stupid default UX design there.
Hello, william,
thanks for letting us know about this issue.
It has been successfully reproduced and put into our internal system.
Kind Regards
Keen Software House: QA Department
Hello, william,
thanks for letting us know about this issue.
It has been successfully reproduced and put into our internal system.
Kind Regards
Keen Software House: QA Department
Replies have been locked on this page!