Assemblers not pulling/pushing items since prosperity update
Submitted
Hello, as per the title the assemblers stopped pushing/pulling items since updating. i have tried grinding them down and laying a whole new conveyer network. it worked perfectly before updating and after it was broken.
I have the same bug
Hello Engineer!
Thank you for reporting this issue.
Unfortunately, I wasn't able to reproduce it on my end. In a fresh vanilla world on 1.210 the assembler pulled iron ingots from a connected cargo container and pushed the finished steel plates back correctly — both with a pre-built assembler and with a newly built assembler, conveyor and cargo container.
One thing worth checking: did you connect the conveyor to the smaller attachment points on the sides of the assembler? Those are not conveyor ports — they are used for upgrade modules that improve the block's stats. Items are only transferred through the large conveyor ports, which worked reliably in all of my tests.
Could you check how your assemblers are connected? It would also help if you could share your save file and let us know whether you are using any mods, and whether the assemblers start working again after reloading the save — that would let us test your exact setup on our side.
Thank you, and best regards,
QA Department
Hello Engineer!
Thank you for reporting this issue.
Unfortunately, I wasn't able to reproduce it on my end. In a fresh vanilla world on 1.210 the assembler pulled iron ingots from a connected cargo container and pushed the finished steel plates back correctly — both with a pre-built assembler and with a newly built assembler, conveyor and cargo container.
One thing worth checking: did you connect the conveyor to the smaller attachment points on the sides of the assembler? Those are not conveyor ports — they are used for upgrade modules that improve the block's stats. Items are only transferred through the large conveyor ports, which worked reliably in all of my tests.
Could you check how your assemblers are connected? It would also help if you could share your save file and let us know whether you are using any mods, and whether the assemblers start working again after reloading the save — that would let us test your exact setup on our side.
Thank you, and best regards,
QA Department
Replies have been locked on this page!