Projection applied when projector is off
Duplicate
I have seen several occurrences now where using a welder to print a projection of a small grid that merges to it's printing mount results in the projection remaining on the grid after the projector is turned off. You cannot see the projection, but the welder can weld it.
I have attached a link to a video of the problem occurring.
I have the same bug Community doesn't accept new feedback!
Hello Engineer,
thank you for reaching our forum with this problem.
However, as you can see, we are already aware of this problem. Please see link:
https://support.keenswh.com/spaceengineers/pc/topic/44448-1-205-26-projector-softlock
As that shared thread is currently in "Reported"/"In progress" state, I will close this one as "Duplicate".
Please follow the shared thread for any new information, comments and possible fix coming.
Thank you for your understanding.
Kind Regards
Keen Software House: QA Department
Hello Engineer,
thank you for reaching our forum with this problem.
However, as you can see, we are already aware of this problem. Please see link:
https://support.keenswh.com/spaceengineers/pc/topic/44448-1-205-26-projector-softlock
As that shared thread is currently in "Reported"/"In progress" state, I will close this one as "Duplicate".
Please follow the shared thread for any new information, comments and possible fix coming.
Thank you for your understanding.
Kind Regards
Keen Software House: QA Department
Replies have been locked on this page!