[Small Grid] Large Hydrogen Thruster Collision Mesh bigger than its model
Reported
Small grid Large thruster block's collision mesh is so big that it cant be placed if another of the same type is in close proximity even if it looks as tho it should easily fit (when subgridded)
How to recreate:
Place a rotor at 45 degree angle
Place down 1 thruster on main grid, and another on the 45 degree angle in close proximity
See picture.
I have the same bug Access denied
Hello Kennet0508,
thank you for reaching our forum with this.
Issue was put into our internal system.
Kind Regards
Keen Software House: QA Department
Hello Kennet0508,
thank you for reaching our forum with this.
Issue was put into our internal system.
Kind Regards
Keen Software House: QA Department
Issue persists in Update 1.206 - Fieldwork
Collision is still too large even after: "Fixed an issue where the collision of Small grid H2 thrusters were larger than needed"
Vanilla doesnt fit
Dlc Version fits
Issue persists in Update 1.206 - Fieldwork
Collision is still too large even after: "Fixed an issue where the collision of Small grid H2 thrusters were larger than needed"
Vanilla doesnt fit
Dlc Version fits
Replies have been locked on this page!