Bug in multi-door airlock airtight detection during rapid depressurization cycling
Environment:
- Game Version: 1.205.026.b0
- Platform: Steam
- Mods: None
I created an airlock grid in this save file and use programmable block to control the door and air vent. When I click the "Depressurize" button on the button panel to clock the inner door and set airlock air vent to depressurize mode, there is often one inner door that is not airtight, although both inner door are closed.
How to replicate the bug: enter the air lock and fast switch airlock mode between "Pressurized" and "Depressurized" by click the left and right button on the green panel quick. (wait for each action to completely finished, until the inner door or outer door open). Soon you will see the air vent in airlock stuck in "Depressurize" mode (blue light) and the oxygen level in room remain still. you will also find another air vent outside the airlock (air vent 3 or 4) keep sending oxygen into it's room, but drained by airlock air vent. All doors between each room are closed.
I have the same bug
Hello Engineer,
thank you for reaching our forum with this problem.
After investigating the problem, we think that there is another - already reported - issue with the same origin, while the outcome is little different. Please see the other thread here:
https://support.keenswh.com/spaceengineers/pc/topic/41150-pressurization-problem
As this thread is currently in "Reported" state, I will close this one as "Duplicate".
Please follow the shared thread for any new information, comments and possible fix coming.
If the problem mentioned there would be fixed, but you would still experience any form of this problem on your side, please feel free to open new thread here on the forum and provide current information.
Thank you for your understanding.
Kind Regards
Keen Software House: QA Department
Hello Engineer,
thank you for reaching our forum with this problem.
After investigating the problem, we think that there is another - already reported - issue with the same origin, while the outcome is little different. Please see the other thread here:
https://support.keenswh.com/spaceengineers/pc/topic/41150-pressurization-problem
As this thread is currently in "Reported" state, I will close this one as "Duplicate".
Please follow the shared thread for any new information, comments and possible fix coming.
If the problem mentioned there would be fixed, but you would still experience any form of this problem on your side, please feel free to open new thread here on the forum and provide current information.
Thank you for your understanding.
Kind Regards
Keen Software House: QA Department
Replies have been locked on this page!