Rotated rotor explodes on attachment
Reported
Blueprint with bug attached, a silly rotor-based elevator design.
To see the bug, run the programmable block four times: "goUpOne" -> "lock" -> "goUpOne" -> "lock"
It reliably explodes on the second use of "lock", it even explodes if you try to "Attach" it manually from the control panel.
I thought this was because the rotor was at ~3.14 rads and the peg was at ~0 rads, but a test using a piston and rotor to attach -> detach -> replace peg at different orientation -> attach correctly updated the rotor's orientation.
The programmable block also has a "debug" function that shows the angles of the two arm rotors, if that helps
Files:
Rotor Bug Test_...
I have the same bug You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!
Hello, Michael!
Sorry to hear you're experiencing this issue. Thank you for providing the blueprint and information. I have successfully reproduced and reported the issue internally.
Kind Regards
Laura, QA Department
Hello, Michael!
Sorry to hear you're experiencing this issue. Thank you for providing the blueprint and information. I have successfully reproduced and reported the issue internally.
Kind Regards
Laura, QA Department
Replies have been locked on this page!