Welders area of effect is messed up
Outdated
Adding a photo of a large welder's area of effect. Missing glass pieces is where the welder is not reaching. Its completely messed up... The welders area of effect is not centered properly and isn't even on all sides. Logically the shape of the area shouldn't be an diagonal square ether as it gives the welder a diagonal reach of just one small block while giving it an uneven reach of 4 small blocks horizontally and vertically. This stuff is just poor and sloppy workmanship and could have been prevented with some simple testing after "nerfing" the hell out of the welders, which by the way was a seriously bad idea.
I have the same bug
Correction: Large welders only have a vertical and horizontal reach of three small squares.
Correction: Large welders only have a vertical and horizontal reach of three small squares.
Hello, Engineer!
Thank you for your feedback! Your topic has been added between considered issues.
Please keep voting for the issue as it will help us to identify the most serious bugs.
We really appreciate your patience.
Kind Regards
Keen Software House: QA Department
Hello, Engineer!
Thank you for your feedback! Your topic has been added between considered issues.
Please keep voting for the issue as it will help us to identify the most serious bugs.
We really appreciate your patience.
Kind Regards
Keen Software House: QA Department
Replies have been locked on this page!