Isolating "Welders" area of effect
So I'm making a printer where I need to isolate the area of effect in close proximity around the tip of the welder. The reason is that as I'm dragging the tip along, it starts to make small blocks inside that tiny space and jams up my hole system. Obsessively you cant place small block there as the tip decides to occupy the entire space around it and when trying to jam it in there using a merge block, you get the message that you cant merge due to them occupying the same space. Using pistons to push it in, would be a possible work around but I don't have the space or the need for it. So basically the collision block around the tip of the welders needs to be tighten to occupy only the space its actually using instead of the entire block it sits in so we can decide where its going to weld or not.
I have the same bug
Hello, Engineer!
Thank you for your feedback! Your topic has been added between considered issues.
Please keep voting for the issue as it will help us to identify the most serious bugs.
We really appreciate your patience.
Kind Regards
Keen Software House: QA Department
Hello, Engineer!
Thank you for your feedback! Your topic has been added between considered issues.
Please keep voting for the issue as it will help us to identify the most serious bugs.
We really appreciate your patience.
Kind Regards
Keen Software House: QA Department
Replies have been locked on this page!