Glass Panel, Armor Panels Not Airtight

James Martin shared this bug ago

Reported

Some combinations of glass panels and armor panels on small grid are not airtight.

Have not checked large grid.

For instance a 2x1 glass slope with corresponding shape armour panels (or even 2x1 slope armor blocks) on the other side will not pressurise.

I have the same bug

Replies (3)

andersenman ●

Recommend you add a screenshot with exactly the blocks and exactly the arrangement that you find a problem with.

Reply URL

James Martin ●

Yeah, I was going to do that when I noticed the issue with glass panels but then I kept forgetting... for about 5 years.

I figured it was better to just post something while I'm on the forum and it's fresh in my mind since introduction of armor panels. Or I'll just forget again and keep compromise building without thinking about it.

URL

Ondrej Borz ●

Reply URL

James Martin ●

Hi Ondrej,

Thanks for the reply.

The bocks I was referencing are the other flat 1x2 slopes.

I should have started with the BP but I just kept forgetting, sorry about that!

I've done up a BP for you with a few other block combos I've noticed over the years that do not produce a solid seal though they appear as though they should.

Files:

URL

Ondrej Borz ●

Hello, James,

thanks for providing this! Now I see I was barking at a wrong tree there :)

There is really issues with these blocks on the blueprint that you provided. It has been successfully reproduced and put into our internal system.

Kind Regards

Keen Software House: QA Department

Reply URL