Conveyer Rotation Bugged
When trying to rotate the conveyer tube and curved conveyer tube, the rotation controls are messed up when placing on a grid.
For example: INSERT rotates it 180 degrees left and right, but only when already at 0 or 180 degrees; DELETE rotates 90 degrees left, as intended; PAGE UP makes the rotation noise but does not appear to to anything; PAGE DOWN rotates 90 degrees right, as intended; HOME rotates 90 degrees left, but only if it is at 90 or 270 degrees; END rotates 90 degrees left, but only when it is at 90 or 270 degrees.
Which key does which changes depending on the orientation of the support block and the orientation of the character. No other blocks are affected, and it only happens when placing on a grid. Setting the placement mode to gravity-align produces a similar bug but with no rotation animation. Setting placement mode to grid-align functions as free-placement. This is my first time placing large conveyers in this world, so I don't know exactly when it occurred.
My modlist is here: https://steamcommunity.com/sharedfiles/filedetails/?id=2196526958
I have the same bug
Hello, Engineer!
Thank you for your report. Can you please confirm this issue also occurs without mods? Unless it can be
reproduced on a clean, un-modded server, it is usually caused by a certain mod or by
combination of mods which we have no control over.
Thank you.
Kind Regards
Keen Software House: QA Department
Hello, Engineer!
Thank you for your report. Can you please confirm this issue also occurs without mods? Unless it can be
reproduced on a clean, un-modded server, it is usually caused by a certain mod or by
combination of mods which we have no control over.
Thank you.
Kind Regards
Keen Software House: QA Department
Hello Engineer,
Since there are no new comments in this topic, we are closing this thread as outdated.
In case anyone is encountering the same or similar bug, which is not already posted in a
different thread, please feel free to create a new thread with all relevant information.
Thank you.
Kind Regards
Keen Software House: QA Department
Hello Engineer,
Since there are no new comments in this topic, we are closing this thread as outdated.
In case anyone is encountering the same or similar bug, which is not already posted in a
different thread, please feel free to create a new thread with all relevant information.
Thank you.
Kind Regards
Keen Software House: QA Department
Replies have been locked on this page!