AI Recorder stops short when near ground (forced min altitude)

Rage_Spammer shared this bug 18 hours ago
Submitted

Platform: PC/Steam

Some background: When the Prosperity Update dropped, I found my refueling drone would stop just short connector range and hover without ever triggering its final action. This same drone had completed this route near flawlessly before that update, so something had changed. I wasn't the only one to notice something was off with drones since a bug report was made (here: https://support.keenswh.com/spaceengineers/pc/topic/55908-ai-block-bug-after-prosperity-update).

Warfare 3 Update: This issue is still present, so out of frustration I did some testing. I found that whenever there was a waypoint close to the ground, the drone would either hover a few meters above it and end its route without triggering the final actions, continue flying at around 18 meters while still targeting the missed waypoint, or looping the approach to the final waypoint (not shown in the vid but did encounter this on a modded save with a different vanilla drone).

Precision alignment on or off does not change the results, collision avoidance is turned off for all my testing, as well as the minimum altitude being set to 0 meters. These settings should mean the drone could lawn dart itself should I tell it to do so, yet it seems reluctant to get close to the ground as if there is a minimum altitude set for about 15m. Modded and vanilla (experimental mode turned off) saves with different grids were tested with the same results. Just for the sake of covering all my bases, I did try turning on collision avoidance, which messed with the pathfinding as it avoided the ground when trying to land, but that's not new and is to be expected with that feature. I also tried setting a minimum altitude of 50 meters instead of 0, and it just hovered above that altitude, which is also expected behavior.

Included is a video link showcasing a successful landing on an elevated platform, attempted landing on the ground that failed, and flying near the ground which also failed. Also included are the saved world used in the vid and the corresponding game log.

https://youtu.be/zjXMTp_YtEw?si=8IEwgPSl3_J1Crcs

Replies (1)

photo
1

Additional note: When testing with setting the minimum altitude to 50m, the drone did not hover at 50m but actually went to 68m then thrusted up to 72m before slowly falling back to 68m and repeating this behavior. This difference of 18m is the exact same as the 18m that it was moving at during the near ground flying test in my video. During that test it was set to a minimum altitude of 0m.

I did not mention this during the bug report because I had not used the minimum altitude feature much before the Prosperity Update, so I wasn't familiar with its usual behavior. However the differences here are too similar to ignore and may prove useful in debugging.

Leave a Comment
 
Attach a file