When not in faction, Broadcast controller set to "faction only" doesn't send message
Reported
Repro steps:
1. Don't be in faction
2. Build a grid with broadcast controller and message inside it
3. Set broadcast target to "faction only"
4. Attempt to send message
5. Observe message not showing up in chat.
This was tested in a singleplayer, creative mode world. It worked irrespective of the "broadcast using antenna" setting
Severity can probably be considered low, but it is confusing to encounter nonetheless.
Behaviour that would be expected most likely by players: Either default to owner only when owner is not in faction (even if "faction only" is selected), or give error message when attempting to select "faction" only as factionless owner.
I have the same bug Access denied
Hello Engineer,
Thank you for reaching our forum with this problem.
Issues was reproduced successfully on our side and put into our internal system.
Kind Regards,
Keen Software House: QA Department
Hello Engineer,
Thank you for reaching our forum with this problem.
Issues was reproduced successfully on our side and put into our internal system.
Kind Regards,
Keen Software House: QA Department
Replies have been locked on this page!