activation of the front motor group for braking
Need More Information
On the panel in the cockpit, I installed a switch for the front engine group. He had to turn them on or off so as not to slow down the ship when flying over the planet. However, when I try to activate this group for braking, the engines do not turn on and the others stop working. At the same time, the terminal displays that they are enabled.
На панели в кабине я установил переключатель для группы передних двигателей. Он должен был включать их или выключать, чтобы не тормозить корабль при полете над планетой. Однако, когда я пытаюсь активировать эту группу для торможения, двигатели не включаются, а остальные перестают работать. При этом в терминале отображается, что они включены.
Files:
Space Engineers...
I tried to add an engine power button to the panel, but it didn't work. The problem is solved only by re-entering the cabin.
I tried to add an engine power button to the panel, but it didn't work. The problem is solved only by re-entering the cabin.
the grid started working after the restart of the world
the grid started working after the restart of the world
I noticed one interesting detail. Every time I turn on a group of engines, the nozzles of the other engines stop working for a moment.
I noticed one interesting detail. Every time I turn on a group of engines, the nozzles of the other engines stop working for a moment.
Hello Eduard,
Thank you for reaching out to us on the forum.
If we’re understanding correctly, the issue was resolved after restarting the world, right? Could you please confirm whether it remains fixed permanently, or if you need to restart the world each time the issue occurs? Also, does the issue stay resolved after you reload the world or restart the game again?
Regarding your second point, where the nozzles of other engines stop working for a moment when you turn on a group of engines, this could be related to a limited power supply. Please make sure there’s enough available power to run all the engines. If power is sufficient, are the engine blocks modded (does the world have active MODs)? If so, make a blueprint of the affected grid, then paste it into a new/unmodded world and check if the issue still occurs there.
If the issue persists, please share a screen recording/video showing the issue, along with the unmodded world save where it happens.
Kind Regards,
Keen Software House: QA Department
Hello Eduard,
Thank you for reaching out to us on the forum.
If we’re understanding correctly, the issue was resolved after restarting the world, right? Could you please confirm whether it remains fixed permanently, or if you need to restart the world each time the issue occurs? Also, does the issue stay resolved after you reload the world or restart the game again?
Regarding your second point, where the nozzles of other engines stop working for a moment when you turn on a group of engines, this could be related to a limited power supply. Please make sure there’s enough available power to run all the engines. If power is sufficient, are the engine blocks modded (does the world have active MODs)? If so, make a blueprint of the affected grid, then paste it into a new/unmodded world and check if the issue still occurs there.
If the issue persists, please share a screen recording/video showing the issue, along with the unmodded world save where it happens.
Kind Regards,
Keen Software House: QA Department
Replies have been locked on this page!