Bug when using Welder block while moving
It may look unnatural because it uses Google Translate.
When generating blocks from a projector, if you exceed a certain speed, only the frame of the block will be placed and welding will not be performed properly.
There are some blocks that are farther away that are welded properly. However, some blocks are not welded properly even though they are closer to the Welder block, and toggling the Welder block does not improve the situation.
Also, if you return to the title menu in this state and reload it, the welding judgment will be performed again and it will be welded properly.
This symptom is not observed at low speeds or when stopped.
It is completely reproducible in my environment.
No mods are installed and the consistency has been checked.
It was confirmed with multiple world data.
Blueprint used for confirmation
https://steamcommunity.com/sharedfiles/filedetails/?id=3514755259
In creative mode or when Enable creative mode tools is checked in Admin Tools, the block is completed immediately, so the symptom cannot be confirmed properly unless you switch to survival mode after calling it from the blueprint.
I have the same bug
Hello Engineer,
Thank you for reaching out to us on the forum! We sincerely apologize for the delay with the response due to the high workload and we want to express our gratitude for your patience with us!
We attempted to replicate this issue on our end but were unable to reproduce it. To help us investigate this situation further, please provide us with a screen recording/video the issue, if possible.
Thank you once again for your patience, and for providing the blueprint as well.
Kind Regards,
Keen Software House
QA Department
Hello Engineer,
Thank you for reaching out to us on the forum! We sincerely apologize for the delay with the response due to the high workload and we want to express our gratitude for your patience with us!
We attempted to replicate this issue on our end but were unable to reproduce it. To help us investigate this situation further, please provide us with a screen recording/video the issue, if possible.
Thank you once again for your patience, and for providing the blueprint as well.
Kind Regards,
Keen Software House
QA Department
Replies have been locked on this page!