Event Controller to monitor Rotor Angle is unreliable
Reported
Using an Event Controller to monitor the angle of a rotor can be unreliable if the rotor switches between negative and positive angle measurements (I.e. 270 vs -90), and there does not appear to be a way to dictate which it will use at any given time. Having it use a normalized value for both sides of its comparison would alleviate the issues.
I have the same bug Access denied
Added note that I have since observed this behavior on hinges which have hard coded range of -90 min and 90 max as well. Hinge sometimes reports position as a positive value between 270 and 360 when it should be between -90 and 0.
Added note that I have since observed this behavior on hinges which have hard coded range of -90 min and 90 max as well. Hinge sometimes reports position as a positive value between 270 and 360 when it should be between -90 and 0.
Hello Engineer,
Thank you for reaching our forum with this.
We have reproduced this issue on our side and put it into our internal system.
Kind Regards,
Keen Software House: QA Department
Hello Engineer,
Thank you for reaching our forum with this.
We have reproduced this issue on our side and put it into our internal system.
Kind Regards,
Keen Software House: QA Department
Replies have been locked on this page!