This object is in archive!
Missing "keep projection" on and off setting in projector action bar commands
Not Enough Votes
"keep projection" has a toggle, but has no dedicated option for "on" and "off" in toolbar config.
Encountered while trying to design safe-in-survival automation for a semi-automatic printing device. Servers sometimes set "keep projection" to off, or it otherwise gets reset when the blueprint is cleared during restarts (not sure the exact mechanism), so I need to make sure it's on when the projector is in use during operation.
I like this feedback
Hello Engineer,
Thank you for reaching out to our forum with this issue.
After discussing this internally, we have concluded that this is not a bug, as these options was never implemented.
For this reason, we are moving this thread to our Feedback forum, as it falls under a new/missing feature or idea rather than a bug report.
We appreciate your understanding, and thank you for your input!
Kind regards,
Keen Software House: QA Department
Hello Engineer,
Thank you for reaching out to our forum with this issue.
After discussing this internally, we have concluded that this is not a bug, as these options was never implemented.
For this reason, we are moving this thread to our Feedback forum, as it falls under a new/missing feature or idea rather than a bug report.
We appreciate your understanding, and thank you for your input!
Kind regards,
Keen Software House: QA Department
Replies have been locked on this page!