Missing "keep projection" on and off setting in projector action bar commands
Submitted
"keep projection" has a toggle, but has no dedicated option for "on" and "off" in toolbar config.
Encountered while trying to design safe-in-survival automation for a semi-automatic printing device. Servers sometimes set "keep projection" to off, or it otherwise gets reset when the blueprint is cleared during restarts (not sure the exact mechanism), so I need to make sure it's on when the projector is in use during operation.
I like this feedback You can't vote. Please authorize!
Hello Engineer,
Thank you for reaching out to our forum with this issue.
After discussing this internally, we have concluded that this is not a bug, as these options was never implemented.
For this reason, we are moving this thread to our Feedback forum, as it falls under a new/missing feature or idea rather than a bug report.
We appreciate your understanding, and thank you for your input!
Kind regards,
Keen Software House: QA Department
Hello Engineer,
Thank you for reaching out to our forum with this issue.
After discussing this internally, we have concluded that this is not a bug, as these options was never implemented.
For this reason, we are moving this thread to our Feedback forum, as it falls under a new/missing feature or idea rather than a bug report.
We appreciate your understanding, and thank you for your input!
Kind regards,
Keen Software House: QA Department
Replies have been locked on this page!