Curved conveyer tube has a hole in model
Solved
The small grid curved conveyer tube has a hole in its model. only on one side
The small grid curved conveyer tube has a hole in its model. only on one side
Hello Robert,
thank you for reaching our forum with this problem.
The problem has been successfully reproduced on our side and put into our internal system.
Kind regards,
Keen Software House: QA Department
Hello Robert,
thank you for reaching our forum with this problem.
The problem has been successfully reproduced on our side and put into our internal system.
Kind regards,
Keen Software House: QA Department
Hello Engineer,
We would like to inform you that the issue you reported was fixed in the 1.206 (Fieldwork) update.
While reviewing a list of resolved tickets, we noticed that we hadn’t posted an update here earlier — our apologies for the delay.
If you encounter any other problems, please don’t hesitate to create a new thread.
I’ll now close this one as solved.
Kind Regards,
Ludmila Danilchenko
Head of Space Engineers QA Department
Hello Engineer,
We would like to inform you that the issue you reported was fixed in the 1.206 (Fieldwork) update.
While reviewing a list of resolved tickets, we noticed that we hadn’t posted an update here earlier — our apologies for the delay.
If you encounter any other problems, please don’t hesitate to create a new thread.
I’ll now close this one as solved.
Kind Regards,
Ludmila Danilchenko
Head of Space Engineers QA Department
Replies have been locked on this page!