Jump drive range incorrect when attempting to jump
Solved
According to every source I've seen, the calculation for jump drives is R = 2500 * J/M where R is jump range in kilometers, J is number of drives, and M is mass in millions of kilograms. Doing the calculations, my roughly 7.3 million kilograms ship with 10 drives should be able to jump 3412 kilometers, however when initiating the jump command, the max range is 465.4 kilometers, roughly 13-14% of the correct range. Not only that, whenever I access the jump drives from a non-cockpit block, it shows the correct range of 3412 kilometers. More concisely, the actual jump range does not equal what is should and is in fact much lower. Am I misunderstanding something or is this a legitimate bug?
I tried attaching a save folder but was unable to.
I have the same bug
Fixed it, turned out I had a ton of resources in my player inventory. No bug.
Fixed it, turned out I had a ton of resources in my player inventory. No bug.
Hello, engineer!
Thank you for reaching out on our forum.
We are glad to hear that the issue has been resolved for you.
As there is no further assistance needed from our side, we are closing this thread.
Please do not hesitate to contact us again if you happen to experience or observe any other issues.
Happy Engineering!
Kind Regards,
Keen Software House: QA Department
Hello, engineer!
Thank you for reaching out on our forum.
We are glad to hear that the issue has been resolved for you.
As there is no further assistance needed from our side, we are closing this thread.
Please do not hesitate to contact us again if you happen to experience or observe any other issues.
Happy Engineering!
Kind Regards,
Keen Software House: QA Department
Replies have been locked on this page!