Safezone left/entered warnings at random times.
In Progress
I dont know if this was reported before, i quickly searched and didnt find it.
Post signal update.
I get seemingly random clicking sound and notification i left/entered the safezone.
It happens when leaving or entering the safezone, but not when the ship touches it, which was normal before the signal update.
Now i get warnings when the ship is half way in, could be when the pilot enters or leaves the safezone, not the whole ship.
I also get them at random times when grinding, welding by hand or by ship tools, at seemingly random times, all inside the safezone.
If i move the ship so a third of it is outside the safezone and move forward-back-forward-back-forward.. i get consecutive warnings i left-entered-left-entered etc..
I have the same bug
Hello, engineer!
Thank you for reaching our forum with this issue. Issue was successfully reproduced on our side and reported into our internal system.
Kind Regards Keen Software House: QA Department
Hello, engineer!
Thank you for reaching our forum with this issue. Issue was successfully reproduced on our side and reported into our internal system.
Kind Regards Keen Software House: QA Department
I also see a lot of these messages when I connect or disconnect a ship grid within a safe zone.
I also see a lot of these messages when I connect or disconnect a ship grid within a safe zone.
Replies have been locked on this page!