Laser Antenna connection bug
Reported
Hi Keen,
We have a problem with Laser antennas connecting to the intended Laser antenna.
Let me explain how you can recreate the bug.
Step 1: Set up 2 identical small grids facing each other.
Step 2: Each grid should have more than 2 Laser antennas and be named properly.
Example
Grid 1 has Laser Antenna A1, B1, C1, D1 ,E1
Grid 2 has Laser Antenna A2, B2, C2, D2 ,E2
Step 3: Connect the laser antennas
If I copy the Laser Antenna coordinate of A1 and paste it to A2 to connect.
A different pair of laser antenna will connect instead.
I have the same bug
Hello, T,
thank you for reaching our forum with this problem.
Issue was successfully reproduced on our side as well. I did report it into our internal system.
Kind Regards
Keen Software House: QA Department
Hello, T,
thank you for reaching our forum with this problem.
Issue was successfully reproduced on our side as well. I did report it into our internal system.
Kind Regards
Keen Software House: QA Department
Replies have been locked on this page!