Locking hinges causes their angle to go from negative to positive
Reported
When locking a hinge the angle goes to the corresponding positive angle, i.e. from -90 to 270,
This causes the event "Angle change" to trigger on event controllers when no angle change has actually occurred, breaking things.
I have the same bug
Hello. engineer!
Thank you for letting us know.
The issue has been reported to our internal system.
Kind Regards,
Keen Software House: QA Department
Hello. engineer!
Thank you for letting us know.
The issue has been reported to our internal system.
Kind Regards,
Keen Software House: QA Department
Replies have been locked on this page!