AI Flight (Move) blocks' Precision Mode isn't fully precise
Please see the attached screenshot and video.
In the screenshot you can see the position at which I created a waypoint using an AI Record (Task) block. You can see the waypoint is created at the midpoint of the block.
However, if you watch the video, when the ship's movement is controlled by an AI Flight (Move) block (with Precision Mode = ON and Collision avoidance = OFF) in addition to an AI Record (Task) block, the Recorder will turn off before the waypoint reaches the midpoint of the block. Instead, it turns off as soon as the waypoint touches the bottom of the block. Given that precision mode is on, I expect the Recorder to stay on until the waypoint reaches the midpoint of the block, since that is where the waypoint was created.
This can cause it to be impossible to get a drone to properly dock to a small connector.
I have the same bug 
Hello, Travis Bruce
Thank you for the screenshot and video. I was able to reproduce the issue and I reported it into our internal system.
Kind regards,
Keen Software House: QA Department
Hello, Travis Bruce
Thank you for the screenshot and video. I was able to reproduce the issue and I reported it into our internal system.
Kind regards,
Keen Software House: QA Department
Replies have been locked on this page!