Large Connector Model Issues
Solved
Hello, I've recently found a few issues with the large connector model.
First, the connector bit seems to be a bit off center.
Second, the base of the connector seems to be barely hovering.
Third, the base also does not look like it aligns properly to itself.
The easiest way to find these issues is to place a connector against itself and rotate it around.
I have the same bug 
Hello, Randy,
thank you for letting us know about this.
Issue has been successfully reproduced and put into our internal system.
Kind Regards
Keen Software House: QA Department
Hello, Randy,
thank you for letting us know about this.
Issue has been successfully reproduced and put into our internal system.
Kind Regards
Keen Software House: QA Department
Hello Engineer,
We’re pleased to inform you that this issue has been resolved in version 205.
As such, we’ll be closing this thread.
If you encounter any other issues with the game, please don’t hesitate to start a new thread here on the forum—we’re always happy to assist!
Happy engineering!
Kind regards,
Keen Software House - QA Department
Hello Engineer,
We’re pleased to inform you that this issue has been resolved in version 205.
As such, we’ll be closing this thread.
If you encounter any other issues with the game, please don’t hesitate to start a new thread here on the forum—we’re always happy to assist!
Happy engineering!
Kind regards,
Keen Software House - QA Department
Replies have been locked on this page!