Event controller may need to update.
I mean if off for some reason then turned back on and it's conditions are met before it was turned on it should update it's output to it's intended purpose. Right?
Ie.
Grid has extra engine's that are default off and only needed when grid is too heavy however if grid is heavy and you wish to turn of all engine's including the extra booster engine's you need to shut them down and the event controller off however turning them on again doesn't update the event output it may even see the conditions are met but won't turn on the boost engine's and if I turn on the boost engine's myself it defeats the purpose of this.
Is there something I'm missing or some other event I should set it to?
If a option was added to control the event controller ie
(toggle on/toggle off)
With new options like
(Update/check event)
Or
(Check event when turned on)
I have the same bug
Hello!
Thank you for contacting us. Since this is a bug report, I'm moving your ticket to our support page, where our QA team will take care of you.
Kind Regards
Keen Software House
Hello!
Thank you for contacting us. Since this is a bug report, I'm moving your ticket to our support page, where our QA team will take care of you.
Kind Regards
Keen Software House
Hello, Evilrobdog,
thank you for contacting us. I was able to reproduce the issue and I reported it into our internal system.
Kind regards,
Keen Software House: QA Department
Hello, Evilrobdog,
thank you for contacting us. I was able to reproduce the issue and I reported it into our internal system.
Kind regards,
Keen Software House: QA Department
Replies have been locked on this page!