There appears to have been changes to the airtightness for this block. The following config used to be airtight but is no longer. There also appear to be other bugs associated with airtightness on its half-width edges as I am experiencing other anomalies with this block.
Half Slope Inv. Light Armor is not airtight when it should be.
Reported
Hello, found a block (Half Slope Inv. Light Armor) that isn't airtight when it should be. In the first picture it's flanked by 2 Light Armor Slope 2x1x1 Base and the room isn't airtight.
In the second picture I have replaced the leaky block with the same kind of block that flanks it in the first picture. The room is now airtight.
I haven't tested with heavy armor if it's the same, but it seems probable.
Best regards
Files:
20250912153634_...
I have the same bug 
Hello, Robert,
thanks for letting us know.
Issue was indeed successfully reproduced and put into our internal system.
Kind Regards
Keen Software House: QA Department
Hello, Robert,
thanks for letting us know.
Issue was indeed successfully reproduced and put into our internal system.
Kind Regards
Keen Software House: QA Department
Replies have been locked on this page!