This object is in archive!
Light and Heavy Armor Corner 2x1x1 Base resets orientation when changing to another block and back
Reported
1.200.029 I read the other report from 3 and 2 years ago. This is still a problem. Not sure why that report is "outdated" when it was never fixed.
I have the same bug
Hello, Engi,
thanks for keeping this issue in the mind and writing it down once more when the original issue was not reproduced properly!
This time, issue was successfully reproduced and put into our internal system.
Kind Regards
Keen Software House: QA Department
Hello, Engi,
thanks for keeping this issue in the mind and writing it down once more when the original issue was not reproduced properly!
This time, issue was successfully reproduced and put into our internal system.
Kind Regards
Keen Software House: QA Department
I just noticed that they conveyor junction block is also resetting its orientation as well. I suspect there are more blocks that do but I've just gotten used to it since they have done it for so long. I would suggest tasking someone to spend an hour orienting and switching to another block and back for all blocks to make sure they are all correct.
Do the same thing for mirroring blocks. Should be no more than an hour.
And finally with textures. The textures also don't mirror correctly. 3 hours total. Then some programming for some really good game polish.
I just noticed that they conveyor junction block is also resetting its orientation as well. I suspect there are more blocks that do but I've just gotten used to it since they have done it for so long. I would suggest tasking someone to spend an hour orienting and switching to another block and back for all blocks to make sure they are all correct.
Do the same thing for mirroring blocks. Should be no more than an hour.
And finally with textures. The textures also don't mirror correctly. 3 hours total. Then some programming for some really good game polish.
Replies have been locked on this page!