This object is in archive!
Separate grid in pressured room does not sense airtightness
Won't Fix
An independent grid sitting inside a pressurized room fails to detect the air pressure.
In this blue, pressurized room, the green grid is floating independently. Its vent indicates the room it is in is not pressurized even though the blue vent on the right is doing an unquestionable job of doing just that.
(From feedback thread https://support.keenswh.com/spaceengineers/pc/topic/pressure-on-independent-grids)
I have the same bug
Hello, andersenman,
thanks for letting us know.
This issue was successfully reproduced and put into our internal system.
Kind Regards
Keen Software House: QA Department
Hello, andersenman,
thanks for letting us know.
This issue was successfully reproduced and put into our internal system.
Kind Regards
Keen Software House: QA Department
Duplicate of, or related to, https://support.keenswh.com/spaceengineers/pc/topic/air-vent-on-sub-grid-does-not-detect-pressurization-state.
Duplicate of, or related to, https://support.keenswh.com/spaceengineers/pc/topic/air-vent-on-sub-grid-does-not-detect-pressurization-state.
Hello, engineer!
After discussing internally, we have concluded that such scenario is not supported/implemented and thus can't be fixed.
We will be closing this thread for now but if you happen to experience any other issue don't hesitate to contact us again.
Kind Regards,
Keen Software House: QA Department
Hello, engineer!
After discussing internally, we have concluded that such scenario is not supported/implemented and thus can't be fixed.
We will be closing this thread for now but if you happen to experience any other issue don't hesitate to contact us again.
Kind Regards,
Keen Software House: QA Department
Replies have been locked on this page!