[publictest] Drawbridge bug

Magnymbus shared this bug 5 years ago
In Progress

The drawbridge cannot be placed on a wall, and can only be placed on floor.

After being placed, removing the floor disconnects the drawbridge from the grid.

If, on the other hand, you place the drawbridge BACKWARDS, assuming it has a floor to sit on, it's fine.

As an aside, the rope doesn't render either.

I assume this is due to the attachment point being on the wrong side.

Replies (4)

photo
1

Thank you for the report. We will look at it.

photo
1

I'll also add that after I place the drawbridge and put the drawbridge down to walk across it, I then fall through the bridge to the ground.

photo
1

I have the same, always place it on a wall so I can make use of its entire length, otherwise, what is the point of placing it.

For me it seems to be related to the focal point of the drawbridge when placing it to the grid, is looks like its in the middle of an expended drawbridge (on the wood part), and therefor you need to have a floor/block underneath at that point when placing. If you later remove that block, the drawbridge collapses.

In the pre 0.7 version it seemed to snap on focal point underneath the pillars of the drawbridge.

Hope this makes sense and helps ;)

photo
1

I usually placed them on 2 pillars, turned 90 degrees to the left. It was the only way I knew how to mount them properly.

Leave a Comment
 
Attach a file