Assembler Recipes Don't Seem Quite Right
Submitted
Sometimes when I go into the production menu and click on certain blocks so that it creates all of the components for said block, it doesn't seem to create everything I need. Usually I am a few motors short or something like that. You might want to go and make sure all of the information for the assemblers has been updated along with changes in component requirements for blocks!
I have the same bug
I have been holding off reporting this issue because I can't quite figure out what is happening... I think it's only when it's pulling some of the resources from another container, and usually you can try to pull them out again and it will do it.
For a long time I was thinking it's just because they're still being produced in the assembler, but I'm not quite convinced of that anymore.
I have been holding off reporting this issue because I can't quite figure out what is happening... I think it's only when it's pulling some of the resources from another container, and usually you can try to pull them out again and it will do it.
For a long time I was thinking it's just because they're still being produced in the assembler, but I'm not quite convinced of that anymore.
Community doesn't accept new feedback!