Conveyor alignment adaptors
Running large conveyors from two points to meet in the middle can result in 2.5m/0.25m = 10 different amounts of misalignment (see misalignment screenshot for illustration). Curved conveyors can only account for offsets of 2.5m or more, anything less than that requires a U-bend that's both ugly and bulky (see U-bend screenshot for illustration).
Proposal: there should be a new set of conveyor alignment S-bend adaptor blocks, all 2.5m long, with large conveyor ports on opposite faces, but with 0.25m, 0.5m, and 1m offsets between the two ports. These can be combined together to account for all misalignment amounts.
0.5m conveyors can also end up misaligned, but the only possibility is a 0.25m misalignment. There could be a single 0.75m S-bend alignment adaptor for small conveyors.
I like this feedback 
Replies have been locked on this page!