Armour block grouping
Not a Bug
Currently there are 5 armour blocks that are not included in a group, I would suggest that they are added to one. My suggestions for how to add them to groups are below:
Half Slope Corner Inverted -> Cube group (1st group on G-menu)
Half Slope inverted -> Cube Group
Half Tall Slope -> Cube group or Half Group (2nd on G-menu)
Slope Transition Base -> Transition Group (4th on G-menu)
Slope Transition Base Mirrored -> Transition Group (4th on G-menu)
I have the same bug
Hello Andrew McAllister,
This is intended behavior. We have not created or assigned these blocks to any groups. Feel free to repost this as a feature request on our Feedback section.
As such, I will close this as Not a Bug.
Kind Regards,
Bartosz
Keen Software House
Hello Andrew McAllister,
This is intended behavior. We have not created or assigned these blocks to any groups. Feel free to repost this as a feature request on our Feedback section.
As such, I will close this as Not a Bug.
Kind Regards,
Bartosz
Keen Software House
Replies have been locked on this page!