Armour block grouping
Not a Bug
Currently there are 5 armour blocks that are not included in a group, I would suggest that they are added to one. My suggestions for how to add them to groups are below:
Half Slope Corner Inverted -> Cube group (1st group on G-menu)
Half Slope inverted -> Cube Group
Half Tall Slope -> Cube group or Half Group (2nd on G-menu)
Slope Transition Base -> Transition Group (4th on G-menu)
Slope Transition Base Mirrored -> Transition Group (4th on G-menu)
I have the same bug Access denied
Access denied
Hello Andrew McAllister,
This is intended behavior. We have not created or assigned these blocks to any groups. Feel free to repost this as a feature request on our Feedback section.
As such, I will close this as Not a Bug.
Kind Regards,
Bartosz
Keen Software House
Hello Andrew McAllister,
This is intended behavior. We have not created or assigned these blocks to any groups. Feel free to repost this as a feature request on our Feedback section.
As such, I will close this as Not a Bug.
Kind Regards,
Bartosz
Keen Software House
Replies have been locked on this page!