Lock and "nudge" mode for building
Not Enough Votes
As in Satisfactory, SE2 would benefit hugely from being able to lock a hologram in place and then nudge it in 6 directions in 0.25m increments. It's very difficult to copy/paste and place objects precisely when we can only adjust it on a single plane with the mouse, and without being able to see alignment properly.
I like this feedback
Reads good to me.
Reads good to me.
Yes, it will definitely help with precise placing big blocks or blueprints on existing grid, especially, if it's too big, to be near, but if characer is far enougth, it becomes difficult to snap projection on grid accurate.
What else could be done, is ability to lock projection in place where you were looking, and if you move or turn around, the projection wiil stay where is has been. You can get closer to look how your projction is placed, and you can use the method suggested above to move projection in any direction, to get it into right place
Yes, it will definitely help with precise placing big blocks or blueprints on existing grid, especially, if it's too big, to be near, but if characer is far enougth, it becomes difficult to snap projection on grid accurate.
What else could be done, is ability to lock projection in place where you were looking, and if you move or turn around, the projection wiil stay where is has been. You can get closer to look how your projction is placed, and you can use the method suggested above to move projection in any direction, to get it into right place
Replies have been locked on this page!