Drill 5.25m one port not mountable
I am not able to add to one side of the 5.25m drill due to the .5m conveyor port not being mountable. The auto block placement will not align to it and using the ctrl key to position the conveyor over the top of the port is not allowed - red zone.
Update: I've been playing around and suddenly was not able to align to the port on the other side of the drill that had been working. I then discovered that I could align the conveyor to the port if I first moved the conveyor around the mount points on a non-port side of the drill and the walk it over to the port. After I did this, it allowed it to align normally each time afterwards. I was not able to get the original port issue resolved; the conveyor won't align no matter what I try.
When holding the ctrl key down the port on the drill is NOT aligned to the .5m grid. The center of the port is between two grid lines.
I have the same bug
Replies have been locked on this page!