[FEEDBACK] Increase Welder/Tool Reach to 1 Meter.
Not Enough Votes
Right now, the welder's aiming range is far too short.
The Welcome to Verdure playthrough was awesome, but you have to get unreasonably close to the object you want to weld for it to work. I highly recommend extending the range to at least 1 meter equivalent away from the tip of the welder. I believe this would be a substantial quality of life improvement over the current setting. The energy-based jetpack would offset the still-reduced reach compared to SE1 very nicely.
Naturally, I'd like to suggest the same for any local proximity-based tool.
I like this feedback
If you are standing on the blocks you are trying to weld, you can barely reach them. You might be too far. So, you step forward. Now, you are too close and the projection turns orange. It is difficult to reach the sweet spot where you are neither too far nor too close. Extending the range of the hand tool a little bit would make it easier.
If you are standing on the blocks you are trying to weld, you can barely reach them. You might be too far. So, you step forward. Now, you are too close and the projection turns orange. It is difficult to reach the sweet spot where you are neither too far nor too close. Extending the range of the hand tool a little bit would make it easier.
Thank you for posting this. I also was frustrated when trying to weld the Fabricator. I found a spot on the front right and left edges that finally let me weld it.
That being said I have really enjoyed the game as it is thus far. It is amazingly beautiful to look at and I am looing forward to the next update. I can't stop talking to my friends about the game!!
Thank you for posting this. I also was frustrated when trying to weld the Fabricator. I found a spot on the front right and left edges that finally let me weld it.
That being said I have really enjoyed the game as it is thus far. It is amazingly beautiful to look at and I am looing forward to the next update. I can't stop talking to my friends about the game!!
Replies have been locked on this page!