Symmetry error when placing block on symmetry plane
Not a Bug
When building a block on the symmetry plane, it gives an error that some blocks
could not have been build.
Likely it is trying to build two blocks in place.
Steps to reproduce:
1. Enter symmetry mode
2. Select a plane
3. Place a block on the plane
See the screenshot
Files:
Example.png
Hello Bryan,
This is intended behavior. This error will indeed appear when the mirrored side already contains blocks in place where you want to place other blocks. It will also appear when placing blocks on the plane where the Symmetry was attached to.
As such I will close this thread.
Kind Regards,
Bartosz
Keen Software House
Hello Bryan,
This is intended behavior. This error will indeed appear when the mirrored side already contains blocks in place where you want to place other blocks. It will also appear when placing blocks on the plane where the Symmetry was attached to.
As such I will close this thread.
Kind Regards,
Bartosz
Keen Software House
Replies have been locked on this page!