Angled Conveyors
Not Enough Votes
Purely for aesthetic reasons, it would be nice to have conveyor corners to also have an 'angled' variant at a 45' angle to the orientation so that we dont have any staircase-looking conveyor lines going up a hill or slope
I like this feedback You can't vote. Please authorize!
You can't vote. Please authorize!
And while we are at it angled doors too, both horizontal and vertical.
And while we are at it angled doors too, both horizontal and vertical.
And while we are at it angled doors too, both horizontal and vertical.
And while we are at it angled doors too, both horizontal and vertical.
This would require, in addition to the 45° bend, a “square root of 2” length part, or better a “flexible/telescoping part” of the pipe/conveyor.
For a “pipe/conveyor” laid in the terrain, probably the best would be a ‘flexible’ part that could be bent to any 0-90° angle while being “stretched” to 2-3 times its normal length. The intermediate parts could then be “normal”.
This would require, in addition to the 45° bend, a “square root of 2” length part, or better a “flexible/telescoping part” of the pipe/conveyor.
For a “pipe/conveyor” laid in the terrain, probably the best would be a ‘flexible’ part that could be bent to any 0-90° angle while being “stretched” to 2-3 times its normal length. The intermediate parts could then be “normal”.
I had a mod in SE1 (sorry, I don't remember the name) that had tube-shaped conveyor hinges. These are visually very nice and opened up a lot of design possibilities. I hope this will be possible in vanilla.
I had a mod in SE1 (sorry, I don't remember the name) that had tube-shaped conveyor hinges. These are visually very nice and opened up a lot of design possibilities. I hope this will be possible in vanilla.
Replies have been locked on this page!