Select block by copy
Not Enough Votes
When placing single blocks it should be possible to point at an existing block to select that block as the next block type to be placed.
It should be an operation that only should require a single click to select <key>+LMB.
I like this feedback Access denied
When placing blocks, you sometimes need to switch back and forth between a few blocks. Each time that you wish to recall a block that you have recently used you have to go back and look through your tool bars to select the block again and again and again. I should be able to quickly have access to the last 3 or four blocks that I have used without trawling through all of the different tool bars.
Alternatively, I need a way to save and load tool bar setups.
Switching between tools and blocks is also a pain.
When placing blocks, you sometimes need to switch back and forth between a few blocks. Each time that you wish to recall a block that you have recently used you have to go back and look through your tool bars to select the block again and again and again. I should be able to quickly have access to the last 3 or four blocks that I have used without trawling through all of the different tool bars.
Alternatively, I need a way to save and load tool bar setups.
Switching between tools and blocks is also a pain.
Replies have been locked on this page!