Change copy/paste 'origin' to whatever block you're looking at
Not Enough Votes
Basicaly what the title says, make the copy funtion like it did in SE1 where the block you were looking at when hitting Ctrl+C/X/P would be the 'origin' or pivot point of the grid.
Would make aligning larger and angled grids much easier.
As a side note, 'the bounding box' for removing blocks in a line or plane is almost invisible
I like this feedback You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!
You can't vote. Please authorize!
This is important when connecting copied pieces that are larger
This is important when connecting copied pieces that are larger
It also should be possible to "nudge" the blueprint.
That way you can adjust the position on the fly.
Maybe something like Ctrl + Shift + (QWEASD)
It also should be possible to "nudge" the blueprint.
That way you can adjust the position on the fly.
Maybe something like Ctrl + Shift + (QWEASD)
Replies have been locked on this page!