blueprint symmetry
Not Enough Votes
have blueprints also work with symmetry so that you can paste somthing on one side have it also happen on the other side
have blueprints also work with symmetry so that you can paste somthing on one side have it also happen on the other side
I like this feedback
I have the same issue, when copying something with CTRL+P then adding it to the station with symmetry on, it does not mirror the copied blocks but just rotates it 180 degrees.
I have the same issue, when copying something with CTRL+P then adding it to the station with symmetry on, it does not mirror the copied blocks but just rotates it 180 degrees.
** Found an actual bug report, posted these there.**
While symmetry works with blueprints, the blueprint is not a mirror image when placed symmetrically to the placement plane. Both blueprints have the same orientation even though they are symmetrically placed.
Unless there is some command to make them mirror one another, they probably should be facing opposite directions.
** Found an actual bug report, posted these there.**
While symmetry works with blueprints, the blueprint is not a mirror image when placed symmetrically to the placement plane. Both blueprints have the same orientation even though they are symmetrically placed.
Unless there is some command to make them mirror one another, they probably should be facing opposite directions.
I was going to put in something like this, but it's a "Mirror" function that lets you perfectly mirror your build. If I build the Starboard Nacelle, it would be nice to hit "mirror" and blueprint the mirror so I can label them Port and Starbird, and be done.
I was going to put in something like this, but it's a "Mirror" function that lets you perfectly mirror your build. If I build the Starboard Nacelle, it would be nice to hit "mirror" and blueprint the mirror so I can label them Port and Starbird, and be done.
Replies have been locked on this page!