pasted blueprints are not generating support blocks in space station
Need More Information
Pasting a ship blueprint above my space base platform is not generating support blocks and therefore I can not start welding components.
I have the same bug You can't vote. Please authorize!
Hello Dave,
Support truss is only generated in Planet's Gravity so that the Blueprint does not fall to the ground. In space there is no need for such supports - you should be able to place the Blueprint and start welding it without any obstruction - remember that it is only possible to weld projections that are touching physical Blocks.
Could you please confirm that is the case for you?
Kind Regards,
Bartosz
Keen Software House
Hello Dave,
Support truss is only generated in Planet's Gravity so that the Blueprint does not fall to the ground. In space there is no need for such supports - you should be able to place the Blueprint and start welding it without any obstruction - remember that it is only possible to weld projections that are touching physical Blocks.
Could you please confirm that is the case for you?
Kind Regards,
Bartosz
Keen Software House
I was getting a "no connection points detected". But I was trying to weld a non-armour block. I see now that I can in fact weld armour blocks in the pasted projections in space.
I was getting a "no connection points detected". But I was trying to weld a non-armour block. I see now that I can in fact weld armour blocks in the pasted projections in space.
I also noticed that if I bump any part of the structure as I begin welding, then the model and the projection starts spinning uncontrollably off in to space.
I also noticed that if I bump any part of the structure as I begin welding, then the model and the projection starts spinning uncontrollably off in to space.
Replies have been locked on this page!