Landing Gear Can't be detached
Submitted
I recently built a ship with retractable landing gear on the ends of pistons. They functioned fine and when they came into contact with the ground they autolocked as expected. However once locked there was no way to unlock them.
I attempted to copy the details from other landing gear blocks that weren't locked and with autolocking turned off. This resulted in bugged out landing gear being listed as 'unlocked' in the GUI however - once you left the control panel and then ren-entered it once again was shown as 'locked'.
I have the same bug
Same here - there appears to no longer be a toggle setting to "Lock / Unlock" in the control settings for either old blueprint item gears, nor newly placed ones. Once a gear locks, the only way to disconnect is to grind it down, and then replace it. (Creative mode - going to test further.)
Same here - there appears to no longer be a toggle setting to "Lock / Unlock" in the control settings for either old blueprint item gears, nor newly placed ones. Once a gear locks, the only way to disconnect is to grind it down, and then replace it. (Creative mode - going to test further.)
Right now, each time I need to interact with a landing gear from a sub-grid (piston/rotor), I need to set two commands per gear on the hotbar, Lock and Unlock. There is no toggle. Two gears, 4 commands etc..
The sub-grid management is hopefully being adressed, this is not a final state.
Right now, each time I need to interact with a landing gear from a sub-grid (piston/rotor), I need to set two commands per gear on the hotbar, Lock and Unlock. There is no toggle. Two gears, 4 commands etc..
The sub-grid management is hopefully being adressed, this is not a final state.
Replies have been locked on this page!