This object is in archive!
Add option to manual input numbers to block settings
Submitted
Would like the ability to type in a specific number for block settings (i.e. Piston Maximum Distance) just as in the PC version. It is very frustrating to use the directional pad to get to a specific number. When you push down on the left or right it jumps wildly to another number, then you have to quickly press and release the pad in order to get the number back to the general area you were looking for, finally spend minutes to get the exact number. If you happen to go to far, well you have to start all over again. Not to mention that when you do press and release the pad, it does not always increase or decrease in the same increments every time (like by 2 or 4 decimal points) it goes 3, 5, 2, 4, decimal points.
I like this feedback
Replies have been locked on this page!