Bridge windows and their gaps
So i know this is probably not a "Bug" but it has been overlooked for a long time. the issue is with bridge windows and the fact lots of them don't have their inverted forms. the new DLC has this issue very plain as day as if you try to make a triangle shaped bridge you will notice that the sloped windows don't have their middle portions to seal it up, and it makes it very difficult to build around it while making it look aesthetically pleasing. sometimes people are able to work around it but in cases such as these (example below) you cant really work around that. and for the original bridge windows we don't have the inverted corners (example below again). i REALLY hope the devs can implement these as even modders don't have a fix for it which is concerning enough.
I like this feedback 
heres another angle of said issue, i tried using some normal blocks but they then stick out on the outside.
heres another angle of said issue, i tried using some normal blocks but they then stick out on the outside.
Hello engineer,
Thank you for reaching out on our forum.
This is not a bug, and there is nothing to fix at the moment, as the Bridge windows are working as designed.
However, we will move this thread to our Feedback section, where new ideas and such are presented, stored and evaluated.
Thank you for your understanding.
Kind Regards,
Keen Software House: QA Department
Hello engineer,
Thank you for reaching out on our forum.
This is not a bug, and there is nothing to fix at the moment, as the Bridge windows are working as designed.
However, we will move this thread to our Feedback section, where new ideas and such are presented, stored and evaluated.
Thank you for your understanding.
Kind Regards,
Keen Software House: QA Department
Replies have been locked on this page!