This object is in archive!
[Automations beta] Recorder trying to dock to moving vessel
Submitted
I posted this under feedback but upon further inspection think it belongs as a bug report. I have had no luck getting a recorded task using the Task recorder block to successfully dock with a connector on a grid moving > 10 m/s. It appears to me that when it reaches the first way point and starts to correct its direction it gets caught in a fight between itself and inertial dampeners. It struggles and greatly misses the connector way point lagging behind. I think either allowing the remote to disable inertial dampeners or to dampen specifically to the "reference" grid would solve this issue.
I like this feedback
Hello, engineer!
Thank you for writing to us.
Please note, for now, docking with a moving target is likely not possible. Drones don't use inertia dampening while moving, but we can certainly consider this feature for future updates.
We are moving this thread to the Feedback section for our designers and programmers for further evaluation.
Kind Regards,
Keen Software House: QA Department
Hello, engineer!
Thank you for writing to us.
Please note, for now, docking with a moving target is likely not possible. Drones don't use inertia dampening while moving, but we can certainly consider this feature for future updates.
We are moving this thread to the Feedback section for our designers and programmers for further evaluation.
Kind Regards,
Keen Software House: QA Department
Replies have been locked on this page!