Much needed new blocks and edits!

With the introduction of the Warfare 2 Weaponry, we need a few blocks that can support custom turrets easier as small grid needs some more love!

1.) 1x1 Small Grid Advanced Rotor: For Small Grid, we already have the 3x3 Advanced Rotor, but why not a small one? Having a small conveyored rotor would give players the ability to make smaller/compact turret designs.

2.) 3x3 to 1x1 conveyor adapter for Small Grid: With the new weapons, MBTs and other simular vehicles can be built completely Vanilla. Unfortunately we don't have a standard block to use for compact turrets, coming off of a 3x3 Advanced Rotor, we only have a couple options to to be able to convert 3x3 to 1x1 for weapons like the Assault Cannon. The original Cockpit is widely used, though the only other options without a turret Cockpit would be a Gatling Turret, Connector, or even the H2/O2 Generator. I propose a new block that is essentially the small grid connector, but without the connector section, so just have the bottom section of the 3x3 conveyor port (to attach to a Advanced Rotor) and have 4 1x1 conveyor ports on the sides, with a 3x3 conveyor port on the opposite side of the first 3x3. Alternatively, the 1x1 Advanced Rotor mentioned above would most likely eliminate the need of this block for most MBT designs.

3.) The Warfare 2 update introduced some amazing weapons, but what is with the collision size of the new small grid turrets? The Autocannon Turret needs some collision attention, it is simply taking more space then it should as the model takes 3x3 space but it is currently at 5x5, which makes using it on top of MBT turrets rather difficult.

4.) The large grid Cylinder Block that was added with the interior blocks, is a beautiful block that was needed, but sadly the collision is just slightly larger then it needs to be, so using it as a subgrid for a lift running against a block wall is difficult as it is fighting against the collision of the other blocks which introduces Clang.

5.) One block that is definitely needed is a half block to full block corner conversion. I've come across the need of a block that can transfer half blocks up to a full for a corner, the 1x2 slope works great, but we need a block that compliments these blocks when coming to a corner.